- Underwire length:
- Is too short on the side, boobs escape
- Bottom of the cup:
- Can't quite fill it
- Top of the cup:
- Cuts into breast tissue (quad boob effect)
- Cups separation:
- Too separate for my boobs
- Cup's width:
- There is empty fabric on the sides (Cup too wide)
- Strap separation:
- Not a problem
Bra » Freya » Lauren Padded Half-cup (4821) » 30DD » Bras » Owner
Measurements
| Measurement | Cm |
|---|---|
| Search by measurements | |
| Fits ribcage | 0.0 |
| B. perimeter | 0.0 |
| Stretched Band | 84.5 |
| Band Length | 66.4 |
| Stretch ratio | 1.3 |
| Cup width | 12.7 |
| Cup depth | 21.6 |
| Depth ratio | 1.7 |
| Wire length | 22.2 |
| Cup height | 0.0 |
| Cup separation | 2.5 |
| Gore height | 5.1 |
| Wing height | 8.3 |
| Strap width | 1.9 |
| Hooks | 2 |
Labeled as
| Index | 30:5 |
|---|---|
| UK | 30DD |
Review
0
like
like
Didn't fit
Oof. This bra is just not shape-compatible with me. Should have known, since I struggled so much with the Freya Patsy as well. Where to begin...
I'm close-set, with tall roots, my breasts have more inner fullness than outside fullness, and have some bottom projection. The Lauren cups are a bit too closed for me due to the horizontal seam, and the shape is a bit too squared off where that seam starts to curve down toward the center of the bra, resulting in a weird puffy pocket of space toward the top of the cup near the gore, despite the edge lying flat.
I also get a perplexing combo of bulging over/gaping at the sides of the bra. Best I can tell, the wires are both too short and too wide for me.This bra is not owned any more
Updated on May 17, 2014 Flag this
