I ordered the Ewa Michalak 3D Bambino Bra in 65F (UK 30F) at the same time I ordered three other 65F 3Ds. While the center gore is wonderfully low and comfortable in all four, the Bambino's cups are significantly higher than those of the 3D Szykus, Satine, and Trapez. Most of that extra coverage is in the area surrounding the center gore. I laid the Bambino under each of the other three, one at a time. The Bambino's cups are, at some points along the top edges, as much as an inch higher.
The 3D Bambino's sides are noticeably lower than those of the 3D Szykus and Satine. I ... have an average width root, I believe, with lots of side fullness. My tissue is apparently quite firm and hard to push front and center unless wires and wings go fairly high. While my boobs are quite close set, their firmness doesn't allow spillage in the center, even with a very low gore and low coverage cups.
The 3D Bambino's combination of relatively full coverage cups and low sides is exactly the opposite of what works best for me.
Another fit issue is the straps. A fetchingly narrow 1/2" wide, the straps are too long even adjusted to their shortest length. This is not even close to being an issue in the 3D Szykus, Satine, and Trapez. The straps' looseness makes it hard to judge whether the cups are the correct size. I believe the cups would fit well if the straps were tightened properly. As it is, the cups gape a bit at the top if I don't stand up straight. To some degree this happens with most bras, of course. Fit is judged when standing in a neutral position, but the Bambino is less forgiving of bad posture because of the loose straps. I am, however, quite petite.
The band feels firm but not excessively tight.
The center gore decoration, a pair of tiny cotton balls, is adorable. They look like miniature cat toys.
Read more
224 more words
This bra is not owned any more
Updated on Feb 18, 2014 Flag this
This feels icky!!! She is successful only because there is no competition... We need to fix that. ;-)